Digitus DN-16054-1 Instalační příručka

OUTDOOR IR NETWORK CAMERA Series INSTALLATION GUIDE Please read instructions thoroughly before operation and retain it for future reference.

10 3.2 Network Configurations via Wizard A quick installation wizard is available via your web browser for password change, date & time settings

11 Step5: In “Date and Time”, check if the date and time setting are correct and modify if necessary. Step6: In “Network”, select the network

12 For DHCP: a) Before selecting this option, you need to finish the DHCP router settings first. Get a router and connect it to the Internet via

13 Step2: In the live page, click “Configuration” to open the configuration page. Step3: Click “Network”  “DDNS”, and check “DDNS Enable”. Step

14 3.3 Network Configurations via Video Viewer 3.3.1 Install the software Step1: Place the supplied CD into your CD-ROM or DVD-ROM drive. The progr

15 Step2: Select “Network” to make network settings based on your network environment. There are three network connection types: Static IP, PPPOE,

16 e) Click “Apply”, and click “OK” to exit the setting page. For DHCP: a) Finish the DHCP router setting. Get a router and connect it to the

17 f) Click “Apply”, and click “OK” to exit the setting page. Step3: Disconnect your camera and your PC, and connect them to Internet separately.

18 APPENDIX CREATING AN ACCOUNT FOR DDNS SERVICE For PPPOE or DHCP, you should enter the host name which points to the IP address of your network ca

19 Step3: The system will automatically send a confirmation email to your email account. Please read this email within 48 hours and complete the pr

2 1. OVERVIEW 1.1 Package Content □ Network camera □ Installation Sticker □ Installation Guide □ RJ45 cable extender adapter □ Ground Wire □ CD

20 Step6: Click “Activate Services” after checkout, and you’re ready to use DDNS services now. Step7: Return to Video Viewer, and go to “Networ

3 CABLE DESCRIPTION RJ45 network cable Connect it to the supplied RJ45 cable extender adapter for cable extension, and prepare another RJ45 network

4 1) Based on your installation environment, put the power & cideo cable through the bracket, and determine the cabling of your camera:

5 2.2 Connect to power Get a power cord and cut off its female connector side. Then, remove the insulating coating to reveal positive, negative an

6 3. ETHERNET CONNECTION Before using this network camera, please follow the instructions below to finish the network connection settings based on y

7 d) In the “General” tab, select “Use the following IP address”, and set the IP address as described below. Note: It’s rec ommended to note d

8 b) In “LAN or High-Speed Internet”, right-click on “Local Area Connection”, and select “Properties”. c) In the “General” tab, select “Internet

9 d) In the “General” tab, select “Use the following IP address”, and set the IP address as described below. Note: It’s rec ommended to note d